Laserfiche WebLink
(b) <br />ii. All signs and sign support structures shall be maintained at all times in a <br />state ofog od repair. The sign components shall be reasonably free of rust, <br />painted if needed and structurally sound. <br />iii. *Controlled Access Corridor signs on properties within the Main Street <br />District/Overlay that have frontage along �State Highway 146 shall be <br />maintained as per provisions of Section 106-874 (3)(a)(b)&(e). In <br />w <br />Section 106-874 (3)(a)(b &Z (d). <br />c. An, new ew on-Rremises freestanding signs shall be a monument or ground sign that <br />does not exceed eight feet (8') in width and height from the ground to the top of <br />the sign (Note: In accordance with Section 106-878(b)(2) signs exceeding 8' in <br />height must be engineered.) <br />d. A Cily permit shall be required prior to any new signage. <br />e. A City approved sign design ma be-eligible� for Cily participation under the <br />Main Street Incentive Reimbursement Grant Funds." <br />Attached on premises signs. <br />(1) <br />General provisions. <br />a. <br />b. <br />(2) <br />(3) <br />One attached sign per building wall may be displayed for each occupant or <br />use on the premises. <br />These regulations do not apply to building addresses or supplemental signs <br />for the purpose of identifying the apartment buildings or units. <br />R-1, R-2, and MHdistricts. <br />rM <br />b. <br />The size of the sign may not exceed three square feet. <br />No portion of the sign may have a luminous greater than 200 footcandles <br />and may not move, flash, rotate or change illumination. <br />R-3, CR, NC, GC, BI, LI, and HI districts. <br />a. <br />b. <br />C. <br />The cumulative size of the signs may not exceed 15 percent of the wall <br />area. <br />If located closer than 50 feet to an R-1, R-2, or MH district, the sign may <br />not flash and must be designed so that it does not shine or reflect light into <br />adjacent residences. <br />6 <br />