Laserfiche WebLink
<br />Fairmont Park East, .on V - Preliminary Plat <br />5/16/02 - P & Z Meeting <br />Page 3 of3 <br /> <br />Conclusion and <br />Recommendation: <br /> <br />. <br /> <br />Section Five. If the intent is for these properties to continue to drain into the <br />detention pond, future drainage plans for these commercial developments <br />must be shown on the Construction drawings for Section Five. Otherwise, <br />these properties must provide individual on site detention. <br /> <br />The proposed Section Five was designed so that all storm drainage flows <br />directly into the detention pond. (The City prohibits any direct drainage onto <br />Driftwood Drive.) The pond's size and capacity were reviewed to ensure that <br />it can adequately serve the proposed development without burdening the <br />existing system. The developer shall provide all the necessary easements <br />required for proper drainage, including storm water inlets. <br /> <br />The Preliminary Plat is in accordance with the City's development <br />regulations. Staff recommends approval of the Preliminary Plat with the <br />following conditions: <br /> <br />. Construction drawings shall indicate off-site drainage improvements to <br />ensure proper drainage of the adjacent commercial property and pipeline <br />corridor. <br /> <br />. As agreed to in the General Plan, the developer is responsible for <br />installation of sidewalks along both sides of all public streets within the <br />subdivision and along east and west right-of-way line of Driftwood <br />Drive towards the end of the subdivision line. <br /> <br />Options available to the Commission are as follows: <br /> <br />. Approval of the Preliminary Plat authorizes the developer to submit a <br />Final Plat. <br /> <br />. Conditional approval of the Preliminary Plat requires submission of an <br />amended' Preliminary Plat and additional documentation as specified by <br />the Commission for final Commission approval. <br /> <br />· Disapproval of the Preliminary Plat requires submission of a new <br />Preliminary Plat. <br />