Laserfiche WebLink
- 202 — Definition of Public Swimirning Pool — Change Summary: Th,is, new definition <br />supports the new code Section 403.1.1 regarding required plumbing fixtures for <br />outdoor public swimming pools. <br />202 — Definition of Swimming Pool — Change Summary: This definition was revised to <br />support the definition of, and intended coverage for, swimming pools as regulated <br />by the International Swimming Pool and Spa Code (ISPS,C), <br />- 305.6 — Protection against Physical Damage — Change Summary: For concealed <br />piping installed through holes or notches, the minimum distance to the face of the <br />framing member without protection has been: reduced. <br />- 308.10 — Thermal Expansion Tank Support — Change Summary; A thermal expansion <br />tank cannot be supported by the piping connected to the tank. <br />- 504.7 — Water Heater Drain Pan Materials — Change Summary: Alurninurn and plastic <br />are approved drain pan materials. Plastic drain pans must not be used under gas - <br />fired water heaters. <br />- 608.12 — NSF-compfiant Tanks for Drinking Water — Change Summary: Drinking <br />water must be protected from contamination from contact with water tanks, <br />coatings on the inside of water tanks and liners on the inside of water tanks. <br />Standard NSF 61 is the testing protocol for determining nonacceptable levels of <br />contamination by components in contact with drinking water. <br />1106.5 — Roof Drainage Scuppers — Change Summary: Scuppers for primary and <br />secondary roof drainage imust be located and sized to prevent the water depth on <br />the roof from exceeding the maximum allowable waiter depth for the structural <br />capacity of the roof structure. <br />PI&ease Note: The Code Changes Listed Above Do Not Include All Changes to the Code <br />