11-16-20 Special Meeting of the La Porte City Council (2)

Browse Search

Clarifications • Following our core value to "Fiercely Protect", our employees are empowered to stop work at any time where they deem the safety of themselves or anyone else is in jeopardy. We will immediately seek to resolve any concerns by engaging with our customer and safety department to elevate the issue which will allow work to resume. • This proposal is based on performing work during normal working hours and at normal wage rates paid by TDlndustries, Inc. • Price is based on the assumption that the structure is of sufficient strength that all piping, duct and equipment can be supported from it. • Proposal is inclusive of all permits and inspections as required by local and state agencies. Where work is being performed under a General Contractor, we will validate under Contractors Building Code permit. • All pricing is based on award of contract and work commence not later than 60 days from the date of this proposal with pricing subject to review after 30 days from the date of proposal. • TDlndustries, Inc. assumes no responsibility for existing services / conditions, their quality and/or performance. • Existing valves must close and hold. • TDlndustries, Inc. assumes no responsibility for condition of utilities or parking lots/roadways above or below grade. • TDlndustries disclaims any responsibility for incorrect data contained in the plan, specs and/or engineering data. • Proposal is based on use of building elevators. Exclusions: • Direct or indirect cost/availability impacts, if any, related to the anticipated tariff on steel and aluminum. • Sheetrock or concrete cutting, removal or patching of any nature. • Cleaning or painting of existing grilles. • Ceiling removal or replacement. • Electrical work. • Electrical temperature control, interlock and power wiring. • Electrical disconnect. • Electrical or power wiring, including conduit or junction boxes or disconnect switches and starter components. • Concrete work of any nature. • Cutting or patching of drywall or block walls. • Cutting or patching of existing pavement for incoming services. • Smoke dampers or smoke ventilation other than stair pressurization. • Insulation of existing un-insulated ductwork. • Modifications of existing ductwork and piping due to conflict with new lighting fixtures or new structural/architectural modifications. • Repairs or modifications of existing mechanical equipment or systems. • Roof cutting and patching unless specified by owner • Roofing work. • Cutting roof deck. • Leveling roof curbs. • Gas piping. • Any pre-existing conditions (gas pressure, electrical, structural). • Any hot water problems that exist outside the scope of the boiler room (mixing). • Additional work required to meet OSHA or ADA standards. • Temp air. • Fire alarm communications. • Air Balancing. Any additional work not listed in the scope above will require written authorization by the customer before TDlndustries, Inc. can proceed. QUO-12327-QOP3Z9 Page 3 of 4