Laserfiche WebLink
approved plans and specifications before the Commission will execute a Subdivision Plat for <br />recordation, or before the City will accept said public improvements for maintenance. <br />(i) Reimbursement for oversizing <br />(1) All improvements required in a Subdivision or Development will be installed at the developer's <br />cost, unless otherwise provided. The cost of utilities and streets which are required by the City to <br />be larger than would be normally needed to serve the proposed addition will be partially <br />reimbursed. The reimbursable amount will be the difference between the cost of the facilities that <br />would be adequate to serve the addition and the cost of the facilities required by the City. A <br />reimbursement contract will be negotiated between the City Council and the Developer. <br />0) Record drawings <br />(1) The engineer representing the developer must present to the Director project information <br />electronically to the City, reproducible complete "record drawings" for all paving, drainage <br />structures, water lines and sewer lines within thirty (30) days after completion of each contract. <br />The Director will not certify approval of public improvements construction until record [all] <br />drawings have been submitted. <br />(k) Fees, Filing/Application fees for plats, plans, waivers or other requirements as established in this <br />Chapter shall be in an amount established by the City and listed in Appendix A of this Code <br />(1) Plat/Plan Graphic Symbols. The following line symbols are established for all plans and plats: <br />(1) Boundaries: Show perimeter boundaries, right of ways and boundary lines between <br />development phases in bold solid lines ( ). Use solid lines ( ) for block and lot <br />boundaries. <br />(2) Building_ lines: Indicate by long dashes separated by short dashes ( _ _ ^ _ ). <br />(3) Easements: Indicate by short dashes ( _ _ _ _ ). <br />(4) Stream and depression high banks: indicate by long dashes separated by three short dashes <br />(5) Edge of flood hazard area: Indicate by long dashes separated by circles ( o o <br />o ). <br />(6) Adjacent proRerties: Indicate lines outside boundaries of proposed development by long dashes <br />(m) Plat/Plan Geometric Standards. The following table outlines geometric standards for plans and <br />plats: <br />Item Description <br />General Plan <br />Preliminary <br />Final <br />Development <br />Subdivision Plat <br />Subdivision <br />Site Plan <br />Plat <br />Dimensional Accuracy Standards <br />27 <br />Thursday, June 09, 2016 <br />