Laserfiche WebLink
(1) All improvements required in a subdivision or development will be installed at the developer's cost,unless <br /> otherwise provided.The cost of utilities and streets which are required by the city to be larger than would <br /> be normally needed to serve the proposed addition will be partially reimbursed.The reimbursable amount <br /> will be the difference between the cost of the facilities that would be adequate to serve the addition and the <br /> cost of the facilities required by the city. A reimbursement contract will be negotiated between the city <br /> council and the developer. <br /> (j) Record drawings. <br /> (1) The engineer representing the developer must present to the Director project information electronically to <br /> the city,reproducible complete"record drawings"for all paving,drainage structures,water lines and sewer <br /> lines within 30 days after completion of each contract. The director will not certify approval of public <br /> improvements construction until record[all]drawings have been submitted. <br /> (k) Fees. Filing/application fees for plats,plans,waivers or other requirements as established in this chapter shall <br /> be in an amount established by the city and listed in appendix A of this Code. <br /> (1) Plat/plan graphic symbols. The following line symbols are established for all plans and plats: <br /> (1) Boundaries: Show perimeter boundaries,right of ways and boundary lines between development phases <br /> in bold solid lines( ).Use solid lines( )for block and lot boundaries. <br /> (2) Building lines:Indicate by long dashes separated by short dashes(____). <br /> (3) Easements:Indicate by short dashes(____). <br /> (4) Stream and depression high banks:indicate by long dashes separated by three short dashes(_——— <br /> (5) Edge of flood hazard area:Indicate by long dashes separated by circles(_o o_o ). <br /> (6) Adjacent properties:Indicate lines outside boundaries of proposed development by long dashes( <br /> )• <br /> (m) Plat/plan geometric standards. The following table outlines geometric standards for plans and plats: <br /> General Preliminary Final Development <br /> Item Description Plan Subdivision Plat Subdivision Site Plan <br /> Plat <br /> Dimensional Accuracy Standards l <br /> Exact:Angles to the nearest second,distances to the X X <br /> nearest hundredth of a foot. <br /> ''Approximate:Angles to the nearest degree.distances X X <br /> to the nearest foot. <br /> Line definition:For all lines required to be defined on a line between two points is considered as "defined"if the <br /> following information is provided: <br /> Bearing(in degree)for tangent(straight)lines X X X X <br /> Distance(in feet)for tangent(straight lines X X X X <br /> Radius of curve(R, in feet)for curvilinear lines X X X X <br /> Central delta angle (A, in degrees) for curvilinear <br /> lines f X X <br /> Arc length(L,in feet)for curvilinear lines X X X X <br /> Cord length(C,in feet)for curvilinear lines X X <br /> Chord bearing(CB,in degrees)for curvilinear lines X Tx <br />