Laserfiche WebLink
Company with a complete set of as -built drawings, Any <br /> substitutigns or changes made by the Contractor /Grantee <br /> for the purpose of fabrication or installation shall be <br /> marked by Contractor /Grantee cn those drawings and <br /> accompanied by a complete revised metes and bounds or <br /> centerline description if applicable. <br /> 5.0 SPECIAL REQUIREMENTS FOR DRAINAGE DITCHES <br /> 5.1 Ditch side slopes along. Company Property shall be <br /> "Asphalt 'Mulch Seeded" with Bermuda grass in accordance <br /> with Texas Highway Department, Item 164. Application <br /> of seed shall be at the rate of forty (40) pounds per <br /> acre. Asphalt Film Spray Emulsion SS -1, CSS --I, CMS -25, <br /> or MS -2 shall be used. This spray is to be applied at <br /> the rate of 0.2 to 0.4 gallons per square yard. <br /> Fertilizer application shall conform to Texas Highway <br /> Department, Item 166 and shall have an analysis of <br /> 16 -8 -8 urea form. <br /> y ALTERNATE: The Grantee /Contractor may use solid "Block <br /> Sodding' on ditch side slopes in accordance <br /> ( with Texas Highway Department, Item 162. <br /> 5.2 Cement stabilized limestone and cement stabilized and <br /> shall conform to Company Specification #007- 224 -06. <br /> 5.3 Unless specified otherwise, the Grantee/Contractor <br /> shall install, for the exclusive use of the Company, a <br /> • culvert crossing for access to Company. Property with a <br /> roadway width of twenty (20) feet. The <br /> Grantee /Contractor= shall install the roadway at the <br /> location_ stipulated in the Agreement or as deteLmined <br /> by the Company Representative. <br /> 5.4 Ditch design shall be such that erosion and slope <br /> stability is controlled by flat side slopes, natural <br /> vegetation, riprap or other approved methods. The side <br /> slopes of ditches shall not be steeper than 4tl. <br /> 5:5 The high ,bank of any ditch shall not be closer than <br /> twenty (20) feet to any structure foundation measured <br /> at ground level unless spproved by the Company <br /> Representative. The high bank of any ditch shall not <br /> ba closer than three (3) feet to any wood poles or <br /> appurtenances measured at ground level unless approved <br /> by the Company Representative. If this is not <br /> possible, the wood poles will be braced or relocated by <br /> the Company at the Grantee/Contractor's expense. <br /> 6..0 SPECIAL REQUIREMENTS FOR STREETS AND ROADS <br /> REV. NO.5 S?EC. Tel. 007 231 79 Sheet 13 of 19 <br />